LD Systems MEI 1000 Brackets
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
EDIT: few mounth since it's in the rack, few thousands km, lot of gigs and still as good as new (thanks to PETG). I…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 65
- Wydruki
- 0
- Wyświetlenia
- 398
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Music
- Licencja
- Creative Commons — Attribution — Noncommercial
EDIT: few mounth since it's in the rack, few thousands km, lot of gigs and still as good as new (thanks to PETG). I just replaced the central 3d piece with a strip of stainless steel collar. It goes through the whole length of the 19" rack to joint the 2 units together (https://www.amazon.fr/gp/product/B0CMPWHWKG/ref=ppx_yo_dt_b_asin_title_o00_s00?ie=UTF8&th=1)
In addition to mineau's design ( https://www.thingiverse.com/thing:5409135 ), I created this short bracket.
My need was to put 3 LD Systems MEI 1000 G2 with only 2 rack unit left. Mineau made jonction boxes in PLA and cut the original metal brackets to put 2 devices on a single rack unit.
I Wanted to keep the original brackets and have the opportunity to put the BNC connector and antenna on the front panel.
Printed with sunlu PETG with 100% infill --> Need it to be sturdy to go on tour with it I didn't tried it on PLA because it may take heat on stage and on the tour van.
The first versions were a bit weak, I decided to make it stiffer adding corner reinforcement and a bit more width.
Buy me a coffee on Paypal: http://bit.ly/3S0XURG
Print Settings
Printer Brand:
Creality
Printer:
Ender 3 Pro
Doesn't Matter
Supports:
Yes
100%
Filament: Sunlu PETG
Notes:
Print on this exact orientation to keep the PETG fibers on the correct orientation.
Printing on an other surface will add weak point on the corner and will break.
Need supports. Tree structure is easier to remove.
Category: Music