Ender 3 V3 SE/KE Bits & Pieces
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Small bits & pieces for the Ender 3 V3 SE/KE - Dust covers, shims, etc...
- Ocena
- 5 / 5
- Polubienia
- 138
- Pobrania
- 658
- Wydruki
- 4
- Wyświetlenia
- 2833
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
DUST_TOP & DUST_TOP_HALF : There are 2 cable passthroughs on top of the Ender 3 V3 SE/KE. One on the left for Z-motor cable, one on the right reserved for customizations. This dust cover stops too much junk from getting in. Just use a bit of glue to stick it in place.
SILICONE_N : Shims for silicone bed spacers.
SPINNY_COVER : I got a spinny spool holder with exposed bearings, this is the cover for it. Should work with the stock spool holder, since they are the same diameter. Just use a bit of glue to stick in place if your print is too loose…
SPINNY_CLIP : “Shortens” the spool handle, stops the spool from moving around too much - Reduces vibrations.
ULTRALIGHT-SHROUD : The “screw pegs” of the original design broke off after a couple of prints from the vibrations. I made a small revision to “beef up” the screw pegs.
G-SENSOR HOLDER : Self-explanatory. Top mounts onto stepper motor on print head. Bottom mounts under the print bed, same as original - https://www.printables.com/model/789443-ender-3-v3-ke-vibration-sensor-mount