Nest Camera Indoor (2nd Gen) Euro-Windowframe Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Places the Nestcam as close to the window as possible, for a high mounting position on Euro/German window frames.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 401
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution
This mount places a Nest Camera Indoor (2nd Gen) upside down on a window frame. It could be used anywhere on the window frame, but I specifically didn't want it to fall off from up high. It is held to the window in our home via Command Strips, so it doesn't drill into or damage the window otherwise.
The Nest camera can be configured to flip the video 180deg, so the image appears right-side up. With the high-up mounting location, you can see a lot of what's outside in a wide area. Because the camera is mounted INSIDE the home, waterproofing, or running power lines through the wall (drilling etc) is not needed to see outside through the window.
There are some common window frame dimensions in Europe, especially Germany. My home, and office, both have the same design (I'm currently in Berlin). However I'm no window expert. The frame on my window is 83.5mm high, and there's just enough room on this mount to add command strips (the mount has 84mm of space).
The windows tilt/open/close functions all work properly with the mount placed near the hinge of the window (see pictures). While not designed for having the window opened fully (because the camera's view is rotated), it works fine to tilt the window open at the top edge, without changing the view substantially.
If 83.5mm doesn't fit your window frame, use the “nestcam-indoor-window-mount-edgeonly.stl” version. This will fit a wider range of frames from 83.5mm and larger. Be sure to have a clean surface for good command-strip adhesion, as that's all that keeps it hanging.
Choose a screw size that is ~3.5mm in diameter at the threads, and 20mm or less in length, to mount the original Nest Cam base plate to the part. The original Nest Cam supplied screws are unnecessarily long.
You may notice in the pic that I put a piece of aluminum (light blocking) tape over the LED. This is so the LED doesn't produce glare into the camera lens at night.
If you are in Germany, be sure to post signs saying that entry to the location indicates consent to being recorded on camera. ;)