Zorro Sword
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Props
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Blade pieces are numbered in the upper side: Front[1-4] & Back[1-5]. You need 16 pegs for alignement.
The grip piece is not reversible, the upper part is marked with T (top).
As the thickness of the guard was very thin I used filament as alignement pegs. You need 5 pieces (1.75x4mm).
Once the parts of the blade and guard are glued, the complete sword can be assembled and fixed with the pommel (which is threaded). It is not necessary to glue them, so you can disassemble it to adjust the pieces or to continue treating them (aka more sanding XD).
It measures 100 cm long from the tip of the blade to the pommel.
The blade is very thin and flexible (only perpendicular to the sharp edge), so it bends a bit if you turn the sword parallel to the ground.
The blade is the same size as my Dread Pirate Roberts sword, so you can also use the same sheath:
https://www.printables.com/model/180517
Sanding, cyanoacrylate, sanding, more sanding, painting, ironed craft foam strip (or leather) and…..zzzzZZ!
