Holster for Sony RX100 M7 with belt loop

I liked the design from @roel.gerrits of his holster for the Sony RX100 compact camera.

First I modified his design with a belt clip/hook. This works fine withPETG, but printed in TPU it deforms too much over time. It probably will still hold depending how much “tension you have between the belt and your belly… ” ;-). 

When you prefer a belt clip I suggest you print my previous design with PETG.

When you print this design in TPU it prevents scratches on the camera, and I designed a belt loop. Your belt should not by wider then 50 mm and/or thicker then 3.5 mm. 
I still added some padding below the inside rim. I used the soft part of velcro tape for this. It gives this “nice feeling” when you slide your camera in or out.  

Supports are for this design not needed. See the 3mf files for info. When you use the 3mf files likely you have to change the material. I have fine-tuned the material settings for the brand (Purefil of Switzerland) of TPU I use. 

Printing this design with PETG is also possible, then do add some protective padding to prevent scratches on your camera. I would not recommend printing in PLA because of its brittleness. 

Be careful, 
I will not be liable when your expensive camera falls to the floor and gets damaged! 
Test before you use!

I use a small carabiner hook on the camera wrist band to secure the camera to my belt in case it fells out. Better safe than sorry.

When you print it please give feedback.