TPH900 charger wall bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
model for 1+1 charger for TPH900 radio thanks to which you can hang the radio on the wall.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 297
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
model for 1+1 charger for TPH900 radio thanks to which you can hang the radio on the wall.
There are two models, male and female, which make it convenient to place and orient on the wall.
For the model I used a nozzle of 0.2mm but it is probably not necessary, I used a layer height of 0.16 and the first layer was 0.2..
4 perimeters and 10% cross hatch fill.
I used 100% filler in the thin areas of the charger attachment and in the area for the screws.
I printed the entire charger at about a 30° slope.
The picture shows the setup for full fill (yellow modifiers)