UGREEN NAS DXP6800 Pro SSD cover replacement
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This replacement cover allows mounting of a fan to the bottom of the NAS, which improves airflow and temperatures.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 63
- Wydruki
- 0
- Wyświetlenia
- 915
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Here are the step-by-step instructions for installing this replacement cover for the SSD bay in the UGREEN DXP6800 Pro NAS. This cover facilitates the mounting of a 120mm fan to the bottom of the NAS, enhancing the cooling and airflow over the SSDs. The cover is compatible with both 'slim' 15mm fans and thicker fans.
Required Components for a slim fan:
- 1x UGREEN DXP6800 Pro NAS SSD Cover Fan Bracket
- 4x Offset Feet for 30mm M4 Screws (35mm offset feet when installing a normal fan)
- 4x 30mm M4 Screws (35mm M4 screws when installing a normal fan)
- Fan Cable Splitter
Printing Specifications
SSD Cover Fan Bracket
- Material: PETG
- Layer Height: 0.1mm
- Supports: Required due to the overhang of the clips
- Note: The clips are fragile; 0.1mm layers provide more cooling time, potentially increasing strength. Exercise caution when removing supports to avoid damaging the clips.
Offset Feet
- Layer Height: 0.2mm
- Supports: Required
- Printing Orientation: Print with the largest gap at the bottom; add support manually to the inside of the offset feet. In Prusaslicer, using “bed supports” leaves a gap. I haven't tried printing with the automatically generated supports because of this.
- Removal: Supports can be easily removed with needle-nose pliers.
Installation Instructions
Prepare the NAS:
- Open the NAS and install a fan splitter on one of the two fan headers for the rear fans.
- Connect the rear fan to one end of the splitter and route the other end to the area with the SSDs.
- Screw everything into place and install the outer shell casing.
Fan Bracket Assembly:
- Screw the selected fan onto the fan bracket, ensuring proper wire management through the notch.
- Bind excess wire securely to prevent it from interfering with the fan blades.
Installing the Fan Bracket:
- Connect the fan to the fan splitter cable.
- Insert the fan bracket into place, ensuring a snug fit, particularly around the clips. Some wiggling may be necessary.
- Secure the fan bracket with screws.
Attaching Offset Feet:
- Replace the original screws on the NAS feet with 30mm M4 screws.
- Position the offset feet on the NAS shell, followed by the original feet on top of them.
- Use the 30mm screws to fasten both the offset and original feet securely.
Final Steps:
- Test the fan to ensure it operates correctly without any obstructions.