Worx M 500 Plus (WR165E) Mower Mud/Offroad Tires
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement offroad tires for the Worx M 500 Plus (WR165E) robotic lawn mower, aiming to provide better traction.
- Ocena
- 5 / 5
- Polubienia
- 19
- Pobrania
- 152
- Wydruki
- 3
- Wyświetlenia
- 943
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Share Alike
I have a few places of mud and/or incline on my lawn that the original mower wheels have struggled with. I wanted to print a replacement tire that uses the original wheels to reduce filament usage and have it look somewhat stock/original.
The stud design is somewhat inspired by the Worx mud wheels and the offroad wheels combined, but I could not stand the retail price of any of those offerings.
I originally tried some wheels I found at Thingiverse, but found them to attract way too much mud when used on my lawn, hence the remix. After a few iterations, I have landed on these wheels, and my mower has not gotten stuck yet. Your mileage may vary.
These tires have been drawn from scratch (using Solidworks for Makers), but heavily inspired by that same slip-on design.
Printing and installation
I printed these using PETG with tree supports. I have tried iterations using PLA as well, but I recommend PETG, ABS or ASA for extended outdoor use. I am sure TPU would provide better grip on slippery surfaces (e.g. rocks, paving, asphalt), but have not tried printing in TPU.
The fit should be tight around the original wheel. I have tried a couple of iterations where I have used screws to secure the tire from spilling sideways, but have found these to be unnecessary on my mower.
To mount the tires, undo the wheel caps using a flat screw driver, then undo the wheel nut using a wrench. The original tire comes off using some force, but is flexible enough that it can be used again if wanted. Slip the tires on each wheel and reinstall the wheels on the mower. Finish off by installing hub caps back on.
Revisions
| Revision | What has been edited |
| rev01 | Initial release. |