1 / 2
B.O.S.S. - Bottle Opener Seatbelt Silencer — zdjęcie 1
1 / 2

B.O.S.S. - Bottle Opener Seatbelt Silencer

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Silence your vehicle's warning sounds and open beer bottles with one simple tool

Ocena
5 / 5
Polubienia
6
Pobrania
117
Wydruki
1
Wyświetlenia
481
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Saw a fake product once that advertised this combo in one tool. Decided to make it real. Think it started as a remix of two different models but eventually I just did it from the ground up. Designed probably a year ago and forgot about. Saw the 20 cig smoker device and knew this would be the perfect companion piece.

 

Designed around use of a penny or dime to take the brunt of the abrasion/pressure against the bottle cap when opening. Insert the coin into the slot with some glue to keep it in place. The print file attached fits a dime and it needs to be pressed into place with an adjustable pliers like knipex, or a channellock wrench.

Currently printing a prototype in PLA+. 8 walls, 6/8 top and bottom solid layers or something like that, 40% gyroid. It's less than 10g in this format, so there's no good reason not to print it totally solid. Support in the coin slot will probably be a pain to remove, so minimize that pain by using 3 layers interface at .3 spacing and use a pick to pry out enough to grab with a side cutters or pliers and then pull it out slowly until the slot is empty.

Use responsibly, my beveraged friend. 

Tagi