HEPA filter box for IKEA LACK enclosure
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
small form factor filterbox for 120mm fan
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 23
- Wydruki
- 0
- Wyświetlenia
- 347
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
update 20/07/2025:
added the internals for the pre-fan filter part. updated the photos a bit as well.
update 23/12/2024:
added the intake and exhaust covers. (for the intake one you can just take the original model. and for the exhaust one you can take the spider one from the thingiverse link below).
I used https://www.printables.com/model/1027-empire-30mm-40mm-fan-guards-star-wars-pattern/ this pattern for the exhaust that I'm gonna use.
Description:
If you are printing ABS or ASA, but basically any material (even PLA!) without good room ventilation, this is a must!
I liked the minimalistic design by JKSniper, but it didn't fit the parts that I had already ordered for this HEPA filter fan duct: https://www.thingiverse.com/thing:3070659
I still have to complete my build, but the place where I am gonna laser-cut my acrylic side-panel of my enclosure is still closed during the summer break so, I'll post an update soon.
To make sure you don't order the wrong parts like I did, here are the parts I used. I linked them below:
- The filter I used: https://nl.aliexpress.com/w/wholesale-Filterset-Philips-FC8645-HEPA.html
- The fan I used: https://nl.aliexpress.com/w/wholesale-ARCTIC-F12-PC-Fan-120mm-Ventilator.html
- Filament I used: https://www.3djake.nl/extrudr/durapro-abs-wit