Yeethammer 2-4x Shell holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A holder for 2 to 4 sillyshells on the side of the Yeethammer
- Ocena
- 4,8 / 5
- Polubienia
- 53
- Pobrania
- 187
- Wydruki
- 5
- Wyświetlenia
- 1018
- Oceny
- 5
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This part replaces the “cam-track-cover” on the Yeethammer to enable mounting of shell holders. The part is designed for the left side, but can be mirrored (X-axis) in your slicer to fit the right side. You may choose to install 1 or 2 shell holders on the cover.
Hardware needed
You will need longer screws to fit the plate.
- 2x M3x16 for mounting the cover plate to the Yeethammer.
- 4x M3x16 for mounting 2 shell holders to the plate.
- 4x M3 nuts on the backside of the plate. I used some CA glue to hold them in place.
Print instructions
The model is oriented in its intended printing orientation. Mirror the cover-plate on X-axis for right side mounting. Designed for 0.2mm layer height. Make sure you have good bed adhesion, or use a brim/skirt to make sure the shell holders won't warp during printing.