Helping Hand LED mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a mount for a 12v G4 LED replacement lamp module ( https://www.amazon.com/dp/B085XTRPGV ) that will fit on the…
- Ocena
- 4 / 5
- Polubienia
- 11
- Pobrania
- 47
- Wydruki
- 1
- Wyświetlenia
- 489
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a mount for a 12v G4 LED replacement lamp module
( https://www.amazon.com/dp/B085XTRPGV )
that will fit on the end of a 1/4" NPT flexi-hose coolant pipe, commonly used to construct "helping hand" soldering aids.
Print Settings
Rafts:
Doesn't Matter
Supports:
Yes
0.2
Infill:
20%
Filament:
any PLA+ or PETG any
Notes:
The lamp shown did not exhibit any significant heating after running 20 minutes @ 13.8v, so material choice is pretty open.
I printed this upright (the pipe mount against the bed) using tree supports and a support blocker for the center portion encompassing the pipe mount.This mount should snap onto the pipe end after removing the nozzle.
Category: Electronics