Telescoping Pencil Holder for 96 Pencils of 10mm Diameter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Telescopic pencil holder with 10mm holes. For the 96p basic pencils, fine liners, Stabilos triangular pencils and so on.
- Ocena
- 5 / 5
- Polubienia
- 11
- Pobrania
- 48
- Wydruki
- 1
- Wyświetlenia
- 277
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is remixed version of the https://www.printables.com/model/943562-telescoping-pencil-holder-for-110-or-75-pencils model.
Credits to @raybetter_104737 for the design and sharing.
Current version has bigger pencil holes (96 in total), so can hold not only basic ~8mm pencils but some fine liners, Stabilos triangular pencils and other, so long it's diameter not bigger then 10mm.
Printing
Print-in-place, no supports.
Two versions included 0.3 and 0.2 tolerance.
Also tolerance tester models included for for both options. So you can check if it will slide and if it actually fits for your pencils.
I've printed 0.2 and got some issues with largest ring. Even though 0.2 tolerance test was ok. It got stuck together. So had to use few hits of the rubber screwdriver handle in order to separate them.
Considering it I would recommend use original 0.3 tolerance.
Material: PLA
Layer: 0.2
Nozzle: 0.4
Time to print base: ~11h (on bumbu a1 mini)
Base weight: 280g