Milwaukee pH probe holder and calibration tank
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The rounded bottom on the cap prevents it from standing up on its own. This has always annoyed me so I made this.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 36
- Wydruki
- 0
- Wyświetlenia
- 147
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial
You are supposed to keep liquid storage solution in the cap but the cap doesn't stand up on its own so I spill it constantly. I got tired of that so I designed this. It will hold the probe upright for storage as well as the cap while the probe is in use.
This is not a replacement cap, it is made to fit the outside of the cap that comes with the probe.
The smaller model is a calibration tank or sample container. It allows you to use a very small amount of liquid since it is only slightly larger than the probe tip.
Prints easily in PLA or pretty much anything.