Carbon Recirculation Filter - Fits Infimech TX
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Carbon/Recirc filter for Infimech TX but probably fits others. Uses 2x 4020 fans ***Check out new version***
- Ocena
- 5 / 5
- Polubienia
- 15
- Pobrania
- 48
- Wydruki
- 2
- Wyświetlenia
- 680
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
*** V2 out now!***
9/17: Carbon chamber got the same treatment as v2 which seems to work better. Will fit existing fan housing and face
Carbon Filter/Recirculation Fan for Infimech TX. Photos show install. Could be mirrored to run two on opposing sides.
Uses 2x 4020 blower fans
Remove fan covers and cut off tabs that hold the clamshell together.
Install 1x M3 heatset in fan housing
Press in left fan and rout wire through channel
Press in left fan
Press on lid. It's a tight fit so I usually have to trim the bulging ends of the inlay. Screw lid to housing
Fill carbon chamber and attach to exhaust
Slide chamber/exhaust onto assembly until it clicks into place
Install behind heated bed with 2 M3 hammerhead nuts and 8-12mm bolts
Wire it how you like but, I wired mine to the fan port that the board cooling fan is plugged into. Moved board fan to always on fan port and replaced with 5v to cut down noise. Filter now runs whenever the hotend is on. Have exhaust fan set to 10% in slicer to keep negative pressure.
Definitely seems to cut down the VOC's. Better than just running the exhaust filter.