Sponge Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Sponge Holder. PLA or PETG. PLA Not dishwasher safe. ABS, ASA dishwasher safe. Center is 35cm wide.
- Ocena
- 5 / 5
- Polubienia
- 96
- Pobrania
- 960
- Wydruki
- 4
- Wyświetlenia
- 3357
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial
Sponge Holder. PLA or PETG. Might work better if you put some supports in for the holes. Some are not perfect but it printed well enough without them. PLA and PETG not dishwasher safe. Melted in the dishwasher. ASA, ABS dishwasher safe. My PLA one deformed in the dishwasher. PETG deformed eventually. Center is 35cm wide and entire unit is approximately 100cm tall. Sponge openings are about 40cm wide.
You want to print this with ASA or ABS. My wife put the PLA in the dishwasher and deformed it. I reprinted in PETG and it is dishwasher safe for a bit but will eventually fail. ABS and ASA are safest.
Print instructions
0.4mm nozzle
0.3mm height
I printed in PLA and melted in the dishwasher. PLA is hand wash only. Will work with PETG depending on how hot the dishwasher gets. ABS and ASA totally fine in dishwasher.
15%fill and standard walls.
I didn't not use supports but may work better with support set around 10.