1 / 3
Low Profile 2 Hole Holster Claw/Wing (Small Footprint)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holster claws that do not extend to the side of the holster.
- Ocena
- 5 / 5
- Polubienia
- 16
- Pobrania
- 179
- Wydruki
- 2
- Wyświetlenia
- 551
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 2) (Komentarze: 2)Remiksy (0)Kolekcje (32)Powiązane
There is a taller version: 25mm rise
and a shorter version: 20mm rise
This design does not extend out from the side of the holster, allowing for a smaller footprint.
There is a slight angle on the face of the claw that assists with angling the holster for better concealment.
Print:
100% Infill
Printed on its side on the wider edge.
PLA does work well, but ABS or other impact resistant filaments are recommended.