1 / 8
ID Card Cover Wolverine | Passport Case | Ausweishülle — zdjęcie 1
1 / 8

ID Card Cover Wolverine | Passport Case | Ausweishülle

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Fun Wolverine themed cover for your credit card sized 54mm x 86mm EU ID-Card

Ocena
0 / 5
Polubienia
19
Pobrania
54
Wydruki
0
Wyświetlenia
491
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Inspired by the Batman Card Cover by @Kubajz0s_1695954 & @JiriSvejda_1874928, this is a newly created Wolverine themed card cover with slide system for easy print and tight fit.

  •    Very low profile, only 3.2mm thick, 2.2mm added to the 1mm high card.
  •    2 or 3 color offset provided as 3mf project files


The head cut out is currently tailored to German and Swiss ID-Cards.

The measures for the new swiss id was kindly provided by @AtikinCrafts_195001

For any other countries, please provide measures for your Card/Country and i will adapt and publish the design for you.

The current design assumes:

   A: 16mm distance from left side of the card to center of left eye
   B: 24mm distance from left side of the card to center of the right eye
   C: 31mm distance from top of the card to top of eyes
   D: 7mm distance from bottom of the card to the chin

Please provide A, B, C, D measures in millimeter and i will gladly make a fitting version.

In case you remix the model yourself to fit your country, i will link it here.


Print advise

It is very important to use dry filament. The top joint frame is only held by 2 perimeters and those should be printed pristine quality for good fit and hold.

Print slowly, its only a 1 hour print even at 50-80mm/s.


Assembly

Put the ID-Card into the bottom base with the slide slot facing left

Slide the top cover onto the bottom base from left to right

In case the bottom base bends or the top is not easy to insert, sand one side of the top cover in a 45° angle to grind away tolerance imperfections.

Tagi