1 / 5
Height-adjustable Studio Monitor / Loudspeaker Behind-Desktop Stand — zdjęcie 1
1 / 5

Height-adjustable Studio Monitor / Loudspeaker Behind-Desktop Stand

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Stand for speakers behind your monitors. Uses 40cm table legs and M10 screws for adjustable additional height.

Ocena
0 / 5
Polubienia
7
Pobrania
16
Wydruki
0
Wyświetlenia
398
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Audio
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This model uses 40cm height table feet with an M10 screw for additional/adjustable height and mounting of a 15°-angled base “mount” element. On top of this, a plate that acts as a stand for the speakers is screwed on the mount.

Requires (per stand):

  1. 1x Table foot with M10 borehole (this was standard for all the table feet I ever bought; adjust this screw thickness if needed) 
  2. 1x M10 hexagon head screw, height as needed (40cm feet + screw height - 2-3cm of screwin = final height of the middle of the plate).
  3. 2x M10 Nuts
  4. 2x M3x25mm countersunk screws 
  5. 2x M3x12 mm countersunk screws
  6. 4x M3 nuts
  7. (optional) Loctite
  8. (Wood/..) mounting screws for attaching the feet to your table

Assembly:

  1. Screw the plate on the angled top of the mount-element with the two longer M3 screws on the higher top and the two shorter M3 screws on the lower bottom, fixated with the nuts from below
  2. Put the M10 screw through the top of the assembly. The hexagon top should be “countersunk” inside the mount element. Fixate the M10 screw from below with an M10 nut.
  3. Add the second M10 nut a few centimeter above the bottom
  4. Screw in the M10 screw into the table foot for at least 1.5-2cm for stability (adjust to your total height needs)
  5. Fixate both M10 nuts with some loctite on the very top and bottom respectively
  6. Screw the whole assembly with the table foot onto your table
  7. Put on your speakers and tidy up those pesky cables
  8. Enjoy!

I also used some black car paint on all screws & nuts to make them look like a part of the table feet.

If everything is screwed in properly and some loctite added, it should be stable enough to even withstand your cat cuddling with it.

 

Tagi