1 / 4
Powerbank (Xtar PB2S) holder for the KiwiDesign headstrap - Quest 3 — zdjęcie 1
1 / 4

Powerbank (Xtar PB2S) holder for the KiwiDesign headstrap - Quest 3

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A holder I made to attach my Xtar PB2S powerbank to the KiwiDesign headstrap for the Meta Quest 3.

Ocena
5 / 5
Polubienia
10
Pobrania
62
Wydruki
1
Wyświetlenia
607
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Attaches by taking off the 2 pads and the the top strap (which are all attached with velcro to the back) and then pulling ithe top strap through the loop that on the back-side of the 3D print. Then just attach everything back as it was.

The bottom triangle tab goes into the gab behind the rachet adjustment knob and prevents the holder from flapping up and down.

Printed in PETG on a Bambu Lab A1. No supports needed. Print on the side.

 

I believe that using the PB2S powerbank with this clip and the Kiwi strap is better cheaper and performs better than the battery strap that Kiwi sells.

The Kiwi comfort strap and the powerbank with 2 cells weights 576 grams.

A Kiwi Battery Strap is 770 grams (6400mAh), while having less battery capacity.

BobovVR S3 Pro = 722g (10'000mAh)

BoboVR M3 Pro = 376g (5200mAh)

With the PB2S, you can hotswap cells whenever needed. Additional cells are also quite cheap, at about 6$/cell (cheaper than other options, like BoboVR's battery packs).

Tagi