Prusa XL X-carriage cover remix for enclosure/new PCCF belt clamps
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Prusa XL X-carriage cover adjusted to work with new PCCF belt clamps (included in XL Enclosure kit)
- Ocena
- 5 / 5
- Polubienia
- 8
- Pobrania
- 49
- Wydruki
- 2
- Wyświetlenia
- 669
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- GNU General Public License v2.0
Put my new XL enclosure together yesterday and could not get the X-carriage cover back on after replacing the belt clamps. From the comments, this did not appear to be an isolated case. Reprinting the carriage cover from the posted file didn't improve matters. The dimensional issues identified in the remix notes became evident after pulling the STLs for the carriage cover and belt clamps into Blender, so…adjustments (and a few not-so-good experiments). Printed on Prusa XL 5 tool with Prusament PETG (Prusa Orange, Jet Black, Urban Grey, and Atomic Filament white (sorry, Prusa Research - you were out of white last time I ordered!)), 0.4mm nozzle with Input Shaper, 0.2mm layers, 5 bottom layers 20% grid infill. Per Bruce's tip at https://forum.prusa3d.com/forum/original-prusa-xl-tool-changer-general-discussion-announcements-and-releases/xl-first-layer-problems-with-petg-nozzle-leaks-while-in-absorbing-heat-mode-filament-blob-screws-up-flatness-calibration/, printer settings adjusted to reduce idle temperature to 150°C from factory profile 170°C. Cover snaps on with a little effort and feels solid with no play once installed.