Inbus / Allen Key Tool Holder - screwdrivershaped
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I wanted a toolholder for all my inbus keys, found one here on thingiverse, but it was flat.
- Ocena
- 5 / 5
- Polubienia
- 12
- Pobrania
- 191
- Wydruki
- 2
- Wyświetlenia
- 1383
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted a toolholder for all my inbus keys, found one here on thingiverse, but it was flat.
I do have a toolbag, which only has pockets for the typical screwdriver, and i wanted something that fit where a screwdriver is, doesnt slip through the pockets, and maybe fans the inbus keys a bit out, so you can get them out easier.
So i modelled this up in fusion 360, did one prototype where all the holes where off, did a second one, and thats the final one you see in the photos.
And i must say, it does that job very well!
Print instructions
Category: Tool Holders & Boxes Print Settings
Printer Brand: TEVO
Printer: Nereus
Rafts: No
Supports: No
Resolution: 0,2
Infill: 15%
Filament: Goedis (GER) PETG Transparent Red
Notes:
Printed on a TEVO TORNADO !
The printer selection is buggy again.
Printing temp was 228°C on a 70°C bed.
How I Designed This
I simply measured the profile of my trusty screwdriver, and put that into fusion, added a few steps through "offset plane", put holes in that, and BAM! there it is.