EIBOS Dryer Mod for Big Spools (5lbs)

I did not make the handle I only increased the holes to fit the screws better. Here is the link to the orig handle. Thanks!

https://www.printables.com/model/778217-eibos-polyphemus-hex-pattern-handle

I set it up so you can buy Plexi that is already cut  for most of it on Amazon or where ever.

You need the following parts:

(2) 10" X 12" 3mm plexi sheets ( prob can use thinner if you have it)

(2) 10" X 8"  3mm ( need to trim to 10" X 7 1/8") I used a multi tool to cut the plexi

(1) 12.75" X 7.75" for the top 

(8) M3  X 20 mm Button Head bolts

(2) M3 X 10 mm Button Head Bolts.

(2) M3 X 6 mm Button Head Bolts.

(12) M3nS - Thin M3 Square Nuts

I am sure you can use other types if you want. 

I use glue to hold the two halves together.

I also drilled 3 holes in the top to let out the moisture. 

I drilled the small holes for the top glass with a 1/8 drill bit.

Drill very slow and take your time and you can drill the holes with out any cracks.   

The larger top holes drill one side almost thru and the flip and finish from the other side, go slow.

Everything should print without supports except the two BASE parts. 

Use Support on Build Plate Only.

And this was my proto type so you can see the glue on the bottom, that is not a crack or hole.