Filler - Self Centering Roller Remix
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This self-centering roller keeps your cardboard spools from walking off the holder.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 31
- Wydruki
- 0
- Wyświetlenia
- 139
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This self-centering roller keeps your cardboard spools from walking off the holder while still featuring a wide flat section to accommodate spools that have a flat interior perimeter. The interior is hollowed out to cut down on print times.
I tested this by spinning a fully loaded cardboard filament spool on it as quickly as reasonable. Even when I deliberately started it off centre or at an angle it always found its centre again quickly. The principal is similar to how train wheels have a slight angle to keep them centred on the tracks.
I hope you enjoy this design and be sure to post a make when you finish making it!
If you are interested in this design you might also be interested in my other Filler remix here: https://www.thingiverse.com/thing:5267457
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
No
Supports:
No
0.2mm
Infill:
~30%
Notes:
You may want to use a brim as this is a tall this print that may get knocked over during printing. Make sure you have your offset dialed in or the quill may not fit into the open end.
A drop of super glue should be all that is needed to seat the quill into the open end.
Category: 3D Printer Accessories