Punisher Zipper Pull Remix (no hole)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is the Punisher Zipper Keychain with no hole. I also went ahead and made the nose wider in the middle because…
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 31
- Wydruki
- 0
- Wyświetlenia
- 120
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- 2D Plates & Logos
- Licencja
- Creative Commons — Attribution
This is the Punisher Zipper Keychain with no hole. I also went ahead and made the nose wider in the middle because when I made it small in size, the nose line would dissapear. This is as close to a match as i could get using 3D builder and Meshmixer.
There are 3 versions in here: skinny nose like original, wider nose with high mesh, and wider nose with less mesh.
I also trimmed a little off the bottom because the nose part was raised up which would cause it to print in the air
Category: Signs & Logos