Mikrotik RMB33G Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A modern case for this Mikrotik device.
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 230
- Wydruki
- 1
- Wyświetlenia
- 1317
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
A modern enclosure for this fantastic Mikrotik device with the following features:
Very tight geometry.
Follows Mikrotik Branding Guidelines.
Air ventilation placed where heat is mostly generated.
Textured enclosure for less 3d printish/more modern look.
Fasteners: Insert Version (IN) / Self Tapping (ST) version.
Only 2 external screws + groove/lip for fastening
Optional multimaterial for Logos and Info, delete them to print recess instead (see sample)
Placement recess for rubber feet, and identification label
Wireless Version (WL) with 2xAntenna holes and extra identification label for wireless adapter
Printing Instructions
Your printer needs to have good dimensional accuracy and handle 0.2mm tolerances.
Layer size 0.2mm
Print with Front and Back plates on platform (see example)
No supports
No brim required, but clean bed properly, adhesion can be challenging.
Assembly Instructions
Install M3 Plastic Inserts (IN version) / See photos
Install M3 machined screws (IN version) or 3mm self tapping screws (ST version) to attach the PCB
Attach Antenna connectors to top case (WL)
Top case must first insert horizontal grove, and then slide forward. See assembly photo.
Note: I have not printed ST variants and monomaterial. Feedback appreciated.
Featured at Mikrotik YouTube Channel, Spotted In the Wild #10.