„Black Box“ 1,4L AMD RX 6400 eGPU Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
3D Printed Box which can contain a AMD RX 6400 xfx Low Profile and the EGPU Deck TH3P4 lite from EXP GDC
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 35
- Wydruki
- 0
- Wyświetlenia
- 1067
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
This box is able to contain a AMD RX 6400 type xfx speedster with a EGPU adapter TH3P4 lite from EXP GDC . The fans on top are two Noctua A6x25 PWM , modificated from N3rdware.com ( connected both cables to one)
I copper modded the rx 6400 with a Copper Coldplate soldered together with a generic copper heatsink from Amazon.com. The original heatsink and fan of the GPU were removed and replaced with the copper parts
. The Coldplate beneath the copper heatsink was CNC milled out of a 3d designed object.
I didnt mill it by myself. I ordered the part from instawerk.de
If you want to do the modifications on your own i can send you the 3d file ( It was not designed by me).
It was designed by the User “REVOCCASES” on the sff Network “smallformfactor.net”
The only thing to do is to drill the holes a bit bigger up to 2.1mm and cut M2.5 threads inside the holes with a thread cutter manually.
Then I soldered it together with lead free copper paste from amazon and inside a small Pizzaoven from eBay . (caution the paste is toxic). The two parts were around 20 minutes in the oven at around 210 degrees celcius
(attention while heating up the parts can move in a direction. I found a solution by taping them together with heat resistand tape. But i would not recommend this , because it leaves black stains on the copper while heating up).
The copper Parts are connected through M2.5 x8 screws with the original springs from the original screws on top of the circuit board . On the Chips and VRAM i put a thermal paste from Noctua
In the end just connect all parts together and you are ready to go.
The EGPU Dock is screwed to the Box with M2x40 Screws which come through the lid and the bottom to the two Threads of the Dock
The two Noctua fans are connected to the Lid with eight M4x30 screws and nuts.
To connect the fans to the Graphics Card you also need a PWN 4 Pin to Micro VGA adapter.
I bought it from amazon.
I posted the progress of this Project on sff Network :
If you want to get inspired or do the project on your own, feel free to read this forum posts where i asked important questions to the user “REVOCCASES” who invented the Coldplate.
https://smallformfactor.net/forum/threads/rx-6400-egpu-copper-mod-in-progress.19690/#post-288992
https://smallformfactor.net/forum/threads/kalmx-amd-edition-radeon-rx-6400-passive-cooling-mod.18476/