Dig2Fo, an LRS-100-5 + DigQuad V3 Enclosure

I created this model mostly because I couldn't find an existing model to meet my specific needs.

Here are a few things to note about this print:

• Print time was ~4 hours for the box and ~4 hours for the lid on a Bambu Labs P1S.
• Box consumed ~160g of White Elegoo Rapid PETG. Lid consumed ~ 60g. 
• I used 3 walls and 25% Grid infill for my print.
• I print PETG with a drastically reduced volumetric speed - 12mm cubed/second hence the longer print times.
• For the lid, I used these 3mm x 6mm heat inserts and these countersunk 3mm x 8mm screws
• For the DigQuad mount, I used these 2.5mm brass heat inserts and this assortment of 2.5mm screws
• The DigQuad mount spacers were created because of small but impactful height differences between several of my DigQuad V3s that were used during the prototyping of this model. Once you've printed the box and lid, install your DigQuad then take a measurement of the height difference between the bottom of the ethernet port (the metal part) and the top of the lid. This measurement will be the height of the spacer you need to print.
• Spacers default to 3mm height. This can be changed in your slicer of choice.

Hopefully this model proves helpful to others. While not necessary, donations are always welcome.