1 / 4
Sonicare DiamondCare Travel Charger Super Slim
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Extremely slimmed down version of the travel charger
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 161
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution
The original travel case for the toothbrush is enormous and unwieldy, but as it turns out the wireless electronics board required for charging is actually pretty small. This model is a compact case for this electronics board.
The model was created using onshape, the workspace can be found here.
Instructions
- Disassemble the original Sonicare DiamondClean 9000 travel case (stock photo of the case is included as the last photo of this model). Unfortunately, it is glued together, but using a set of spudgers and a bit of persuasion should do the trick.
- Remove the electronics board and the cable.
- Print the model in PLA
- Slide in the electronics board, so that the wireless coil is pointing up, guide the cable through the hole. See photos for reference.
- Close up the case with the lid. The parts fit together pretty snugly.
- Test if the toothbrush is charging if it is stood up on the case.