Basic Wind Turbine
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Wind turbine design using a DC motor with a 2mm shaft that's capable of producing small amounts of electricity.
- Ocena
- 0 / 5
- Polubienia
- 443
- Pobrania
- 1087
- Wydruki
- 0
- Wyświetlenia
- 8363
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution
A basic wind turbine design that can produce enough electricity to power a small LED light.
I manged to print all of the parts on a stock Ender 3 using PLA, so it should print fine on any printer out there.
How to print:
- Material: PLA, PETG, ASA
- Layer Height: 0.16 - 0.2mm depending on how well your printer handles overhangs
- Infill: All parts but the rotor blades should be printed with 30% infill, the rotor blades should have 30% infill at the base and 5% from where the blade starts.
- No supports are needed
Parts needed:
- x3 Short M3 screws
- x1 24mm DC Motor with a 2mm shaft
- x1 32mm PVC Pipe
- x1 15x32mm Bearing
How to assemble:
Assembly of the rotor and the motor holder.
All parts should press-fit togheter after using a bit of force.
Final assembly.
Main_Back requires x3 M3 screws in order to properly attatch to Main_Hub. All other parts should press-fit.
I would highly recommend to glue all of the press-fit parts togheter so that the turbine can withstand stronger winds.