Emporia Vue V3 ESP home flash jig
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A jig to help out when flashing your Emporia Vue V3
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 115
- Wydruki
- 0
- Wyświetlenia
- 1450
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
Edit:
The jig has been remixed and improved by another printables member! Please see: https://www.printables.com/model/1152988-emporia-vue-v3-esp-home-flash-jig-w-fixed-toleranc/comments
Good luck with your project!
Also I made a mistake. I forgot to tell everyone to get the drill bit to make the holes the perfect size!!! If I remember correctly you'll want a 0.7mm drill bit
Original:
I didn't want to solder onto this guy, so I designed this jig. I printed with a 0.25mm nozzle in PLA. Print flat side down.
You'll need Pogo Pins .68 diameter could use larger pogo pins for the thru hold pad:
I used a probe tip for the IO0 port, but you can buy a larger pogo pin diameter, which will require soldering to it:
You'd do good to hot glue those pogo pins/jumper wires in there to keep them put. Spacers are available if you need them to accommodate your screw. Hope this helps!
Michael Woodcock (buymeacoffee.com)

