4080 or 8080 simrig cable management
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Flexible cable management for 80mm faced aluminum profile for simrigs / simpits / sim racing
- Ocena
- 5 / 5
- Polubienia
- 76
- Pobrania
- 393
- Wydruki
- 2
- Wyświetlenia
- 2019
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Flexible cable management for xx80 profiles. 200mm, 100mm, and 50mm for varied run lengths.
Mostly intended for simpits but anything that uses xx80 profile and has cables can benefit. Saw a few other models for different profile sizes that I liked, but I needed it for 80mm profiles and had a few other design requirements.
- Print easily (minimal supports, no special tuning, etc)
- strong and flexible
- Easy to put on and take off incase I need to re-cable anything.
I designed these in fusion and am happy with the results. Can fit 3-8 cables, depending on how chonky they are. Print as many as you need and cover all long runs of your simpit for a super clean (and safer) install.
Prints clean on the default .2 layer profile. Thicknesses set to exactly what is required for zero infill, achieving a good balance of strength, filament efficiency, and flexibility.
It's probably painfully obvious, but I'm not an engineer and mostly been learning CAD through designing little projects for the house. Constructive feedback and requests help me learn, the more the merrier.