Subaru Monkey Bone Racing Vent Pod Redirector

If you installed the MBR Vent Pod to allow you to replace your center two vents with gauges, then you know that you pretty much lose any and all airflow that used to come out of those vents.

The problem is that the airflow does not get routed to the small vents on the side.  It all just hits the back of the gauges and just about nothing comes out of the vents on the side, rendering your center vents totally and utterly, useless.

The Monkey Bone Racing vent pods I built the airflow redirectors for can be found here:

http://monkeyboneracing.com/product/vent-pods/

I have only tested these on my 2013 Subaru WRX STI, but in theory, they should work for any of these Subaru years and models:

• Fit: 2008-2013  Subaru WRX & STI
• Fit: 2008-2011 Subaru Impreza
• Fit: 2009-2013 Subaru Forester

You'll never get 100% of the airflow you used to, but this model forces the air out of the side vents for a very noticeable difference in your airflow.  As in, you actually have quite a bit, now.

When installing, the lip should be on the bottom and the vent should be on the side you are installing it on to maximize the amount of the air coming through the ducts and forced out the vents:

I printed these in PETG because I did not want the PLA to warp when it gets crazy hot in the summer (or possibly with the heat cranked up in the winter).  Your PLA mileage may vary depending on your climate.

Print settings:

• Printer: Creality Ender 3 V3 KE
• Filament: ELEGOO Rapid PETG (black)
• Nozzle: 0.4
• Layer Height: 0.2
• Infill: 15% (Adaptive Cubic)
• Brim: Yes