Eyesen 8mm Scanner Tilter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This tilts the 8mm Scanner back about 10degrees so bigger film rolls don't fall off. Should work for the Wolverine too!
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 173
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
This is to fix a problem with the Eyesen 8mm + Super8 Film Scanner where the film rolls fall off the front, or the scanner itself falls over.
The scanner itself is oddly balanced so it's pretty front heavy - adding a full 7" roll of film on there makes it even worse. This tilts the scanner back by about 10 degrees and makes it much more stable.
Print both sides (one's just a mirror of the other) - If you've got the thick double sided tape, put that in the little recessed bit, otherwise put thin double sided tape on the open space.
I pulled the foam bits out from the current feet of mine and stuck them onto the 3D print to stop any vibrations.
Print Settings: Nothing complicated about this one. I printed mine with 20% infill and that was probably overkill. No supports needed.