XL 90mm/3.5 inch Bias tape maker (for sewing, making double fold straps)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Too much of sewing is pinning and measuring! I got tired of making double fold straps so I made a giant bias tape maker.
- Ocena
- 5 / 5
- Polubienia
- 36
- Pobrania
- 87
- Wydruki
- 2
- Wyświetlenia
- 913
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Fashion Accessories
- Licencja
- Creative Commons — Attribution — Share Alike
Too much of sewing is pinning and measuring and I get bored easily! I got tired of making double fold straps so I made a giant bias tape maker instead. This is for 90mm/3.5 inch wide fabric strips.
This was made using the customizer by Neon22 on Thingiverse in OpenSCAD. I was using twill, so I made the stabilizing piece quite large and set the opening for the fabric a bit larger to compensate for the bulk. This opening may be too wide for super lightweight fabrics (like chiffon) and too narrow for super heavyweight fabrics (like thick polar fleece). Consider your slicer/printer's tolerance abilities as well (mine is about .15).
.3mf file that I used attached. You can convert to STL in some slicers if you'd wish, or let me know if you would like me to do so.
I printed in PLA vertically with a brim and had no issues. My printer and filament settings in my slicers were not perfectly calibrated, either.
- You do not need excessive infill, it is not a fragile piece.
- However, I would avoid using a filament that you know is a more brittle PLA because of the thin guide in the center of the opening. It is thicker than normal, but still thin.
- Print does not require any post processing beyond ripping off the brim. (If you experience stringing, dehydrate your filament and set your filament's retraction settings).
- The iron does not melt the PLA from being near it.
Since the stabilizer has to be quite long for such a wide strip of fabric, the hole in the top is for pushing the fabric further through. I used the sharp end of a seam ripper. Use fine tweezers or a seam ripper to pull the fabric out from the end if it's stuck. Make sure the end of the fabric going in isn't frayed (pinking shears can be handy here).
Example of finished straps shown in 3rd picture.