Coil Master organiser
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a little tray thing to organise the parts of the old coil master kit.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 96
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Medical Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a little tray thing to organise the parts of the old coil master kit.
It holds all the parts below in a way that the size markings are easily visible and the resistance tester comfortably sits in a cutout on top.
The holes for the rods are sized for each specific size rods.
For printing you need to enable polyholes in your slicer if it has that setting for more accurate holes.
After printing the holes will be slightly too tight, to make them a perfect fit you need to heat up each rod with a lighter until its hot enough to deform but not completely melt the plastic and carefully push it into the hole and move it up and down until the rod fits snugly without requiring too much force to pull back out.
pla plastic starts softening at 60c, you don't need much heat!