1 / 1
Anker Powerhouse 521 - Backplate North American (1-15P) Plug Tightener
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Quick print & install mod for the Powerhouse 521 cable storage backpack - fixes tolerance for North American charger.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 97
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Share Alike
Printing
- Printing in PETG recommended (not tested in PLA, likely to lose friction fit if left in a hot car).
- Print with 0.2mm layer height flat on the print bed - there is a slight taper to aid the friction fit.
- No need to mirror, friction fit works in either orientation for each prong.
Installation
- Gently install each of the clips until you feel resistance (do not press fit them yet!). Orient them flat side facing outwards, curved side towards the slots where the blades will go.
- Use your charging adapter to complete the press-fit. Insert your charging adapter and apply pressure until they are flush.
- This will ensure that the clips do not ‘skew’, as the blades will help keep them aligned as they encounter more resistance.
- Using the charging adapter also saves your fingers from any strain, and avoids deformation from small tools (which would likely ruin the friction fit tolerance).
Notes
- Installation is ‘permanent’ - you will need to dig these out with a small sharp tool if you want to remove them. No glue is required.
- Installation is mutually exclusive with BSE 1363 plugs - once you install these, you will not be able to store BSE 1363 plugs. Not anticipated to be a problem for the intended use case in North America.