Sawyer Squeeze Drip Cap
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Print in place cap for your Sawyer Squeeze, avoid drips when stored away in your pack.
- Ocena
- 4 / 5
- Polubienia
- 27
- Pobrania
- 128
- Wydruki
- 2
- Wyświetlenia
- 975
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Do you hate when grungy mysterious pond water soaks your fresh undies during a backpacking trip?
Well here's a cap for the unfiltered side of your sawyer squeeze water filter.
Print in place swivel so the cap can turn freely and is secured to the filter so you don't lose it.
You'll need about 12 inches or 32mm of 550 paracord, remove one internal core strand and tie it around the groove of the filter.
Will attach my .3MF file, but pretty standard settings;
15% infill
2 wall
No supports needed
Printed in PLA or PETG
Print Orientation standing up from seal surface
For post process; use a thin kitchen knife or card to break loose the seams around the swivel, and give it a good spin to work it in.
------------------------------------------------------------------
Included .stl/.step/.3mf files
If you're happy with the design, and had a successful print, AND you're feeling generous, you can tip me no more than a buck or two on my PayPal:
Appreciate those that do! Thanks