Shampoo Bottle Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple part designed to hold your shampoo upright or upside-down.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 142
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Public Domain
This is a simple shampoo bottle holder for the shower. It is designed to hold your bottle upright or upside-down without tipping over as easily.
My shampoo bottles use sphere-ish caps, which makes storing them upside-down (to get that last bit of conditioner out of the bottle) incredibly frustrating. This part just helps the bottle stay where I want it without falling over. The part has multiple drain-holes to keep from retaining water and uses the no-slip feet to slightly raise it off of the shelf-floor to allow adequate air-flow and drainage.
Parts
Assembly
- Stick the no-slip feet into the sockets on the bottom of the part
Print Settings
- Support: None
- The rubber-feet sockets may droop a bit with PETG, but its fine, these are covered with the rubber feet anyway
- Filament: (almost) anything
- I used PETG, but this should work fine with PLA and other filaments
- Perimeters: 3
- Infill: 20% Gyroid
- Mostly for weighting the part down
Source CAD
I used OnShape for this design and you can find the public document here: https://cad.onshape.com/documents/0057d60a310f9d47d1d05498/w/fd362080d23c943c671fff1f/e/c831359f6a1c21b1a3a33d82?renderMode=0&uiState=66c756aa4d558b234dfba1db
Everything is variable-driven, so you can easily remix this to fit your own shower bottles. You can then right-click on the part names in the list on the left side to export them as STLs/STEP files.