Lotus58 Case (USBC)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Tested with version usb-с v1.40, but should work with subsequent versions.
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 201
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
For each half you will additionally need 10pcs m2 6mm screws and 5pcs m2 8mm spacers.
The spacers can be quite tight, so you can try heating them up a bit, or using a screwdriver to screw them in. If the printer is set up well, they will just fit snugly.
The versions with holes in the back are needed to attach the 10mm rubber feet.
PLEASE NOTE that the left and right side are not mirror copies! There is a difference between them in the form of the position of the usb-c hole.
Also, this case fits usb-c connector with 1.6 mid mount (shown in the picture). If you have a different mid mount distance, you need to change that in the step file.
Print Settings
Resolution: 0.16mm
Infill: 100%