Print-in-place resistor organizer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Based on OpenSCAD print-in-place drawers
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 95
- Wydruki
- 0
- Wyświetlenia
- 524
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Share Alike
The resistor cabinet has 12 drawers, each with 5 compartments, of which 52 are pre-labeled with common values. The dimensions are 240mm wide, 80mm deep, and 140mm high. Each compartment holds at least 50 resistors on tape, probably 100 resistors loose. The print-in-place organizers can be tie-wrapped together as shown in the last photo.
Ceramic capacitor organizer: https://www.printables.com/model/983369-print-in-place-ceramic-capacitor-organizer
Electrolytic capacitor organizer: https://www.printables.com/model/986897-print-in-place-electrolytic-capacitor-organizer
This is the resistor kit: https://www.amazon.es/-/pt/dp/B0B2CY3SW3/ or https://www.amazon.de/-/en/dp/B0B2CY3SW3
The cabinet & drawers print all at once. Import resistor_cabinet.stl and resistor_cabinet_text.stl simultaneously into the slicer if you want colored text. resistor_cabinet_no_labels.stl should be used if you want to make your own labels.
This model is based on my OpenSCAD model for parametric print-in-place drawers: https://makerworld.com/en/models/481479#profileId-397133