GoPro 12 Protective Case

¤#¤ What's new! ¤#¤

• Better lens protection
• Wider opening to view front screen
• Fit test

-+- There are five cases and two lids: -+-

All cases have the same form factor and fit the GoPro Hero 12. Choose one (or all if you want):

• Fox 
• Fox head
• Bird
• phoenix
• No figure

The case uses the GoPro tabs to stay in place, but the lid has a small latch for redundancy. There are two versions of the lid. Choose one (or both if you want):

• Lid showing the screen
• Lid fully covering the screen

You might need to scale the model before printing. Use the “Fit_test.stl” for quick prototyping!

-+- You need one of each following item: -+-

• Case
• Lid
• M5 screw with a minimum length of 30 mm
• M5 locking nut and/or glue

-+- Printing settings: -+-

• 100% infill
• Layer height/Quality: 0.1 mm (0.4 mm nozzle)
• Use support
• Use brim to avoid warping
• Lid: Oriented laying down. Hinge and latch up (Use support)
• Case: Oriented camera facing down (Use support)
  • This way you get a clean surface on the inside of the case

=+= If you liked this model =+=

Check out version 3 with even better lens protection!

-+- Case figures based closely on: -+-

• Fox by Nirmla 
• Fox head by Michael
• Bird by Jakir Hossen 
• Phoenix by idesign2000