Topping DX3 Pro+ bracket (remix)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of Topping DX3 Pro+ bracket by Paetthe
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 30
- Wydruki
- 0
- Wyświetlenia
- 314
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Remix of Topping DX3 Pro+ bracket by Paetthe (https://www.printables.com/model/811508-topping-dx3-pro-bracket)
I added holes on the other side of the bracket to make it easier to mount using screws. Simply hold the amp and brackets together using tape and screw under your desk, the tape can then be removed. This means you don't have to line up the 2 brackets to be paraelle and the correct distance apart.
If you don't want to mount using screws, you should use Paetth's design as it is easier to print and prints in a stonger orination as well.
I printed in PLA at a 0.2 layer height, make sure you enable organic (tree) supports, and make sure there very strong and help well to the bed as they need to be quite steep.
If you experience support failures, a few settings to play around with are 1st layer expansion (this controls the size of the brim at the bottom of the support, I incrased to 8mm,) line (extrusion) width for supprts (I increased to 150% of nozzel size) and support wall loops (I incrased to 2.)
If you want to play around with the designed, the tinkercad link is https://www.tinkercad.com/things/jHM4hNTFtEa-topping-dx3-pro-bracket