Storagebox Teardrop-Campingtrailer

This storagebox comes with a sliding closingmechanism and for my outdoorfriends a clip on the side for maps i. e. 

There is actually not much to say about the print, but the amount of parts you need for a proper model. Print everything in the needed amount and the recommended printdirection as said for a good solution:

1x trailer (as a real trailer would stand)

2x tire (laying down with rim upwards)

1x inlet (flipped to the side)

4x inletbolt ( standing upside down)

19x roof tile (standing lenghwise upwards)

1x roof tile front (same as roof tile)

1x roof tile rear (same as roof tile)

1x front support (standing upside down)

1x lockscrew counternut (laying down normal)

1x lockscrew handle (standing normal)

1x lockscrew latch (laying down normal)

Every partmodel already has tolerances for a nice fit with each other (threads work as well).

Make sure to turn on supports and an infill of any percentage.

The only part to be glued are the tires since everything else will be screwed.

Have fun! :)