1 / 3
MG Midget 1500 - Holley Sniper 1100 to Factory ZS Intake Adapter — zdjęcie 1
1 / 3

MG Midget 1500 - Holley Sniper 1100 to Factory ZS Intake Adapter

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This adapts a Holley Sniper 1100 to the factory Midget 1500 ZS intake manifold.

Ocena
0 / 5
Polubienia
8
Pobrania
22
Wydruki
0
Wyświetlenia
302
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution

This will adapt a Holley Sniper 1100 to the 1500's factory ZS intake. The adapter also has a built-in 3° taper that will mount the Sniper at the slight upward angle. This solves any issues with the fuel pooling in the throttlebody and running out of it's mouth.

 

You will need to remove the (2 carb mounting studs from the factory intake and instead use (2) Ø5/16"-24x ½" long flat head machine screws. If you can't find flat head screws, you can print (2) of the conical washers in order to use regular bolts.

 

I'm not sure if the factory throttle bracket that mounts to the intake will still work with this due to the added thickness compared to the factory carb isolation spacer, but if it doesn't, it shouldn't be too difficult to make a plate that will move the bracket the little bit.

 

I would print it out of something that can withstand both the heat of the nearby exhaust manifold and the gasoline that will come into contact with it. 

Tagi