OG Star TrackerV1 phoneholder-Alternate polar alignment Insert AlphaV3
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A phone holder for the og star tracker. Used to align north when access to Polaris or a polarscope is not possible.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 478
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is my first ever 3D printable model.
Recommended apps to use:
Compass:
- NOAA mobile declination compass web app
- Trail Sense (if no internet)
Inclinometer app:
- Clinometer
- Trail sense
I think this alpha is good enough up to 120 second subs (tested with a 80mm lens) until I get a modular version created, you just need to make sure you're absolutely level, and that the NOAA mobile declination compass (link) is centered with your phone resting on the holder. You can set your celestial declination to your geographic latitude using an app like ‘Clinometer’ while your phone is resting on the holder to get a declination reading. For example, I live at 45.4 latitude so I adjust the OG Star Tracker declination until the Clinometer reads 45.4. I find Clinometer is the most accurate and never gives a false reading.
Compass note: When I set my compass, I wait 3-5 minutes for the compass to adjust for near perfect alignment. This can be fickle though, I've had to offset the north alignment by up to -3 degrees (357) on some nights. I think it is sensitive to solar storms. If you can find a better compass app please share in the comments. One other consideration is that the stepper motor on the OG star tracker will throw the compass off, so try to lay your phone as far right as possible to avoid a false reading.
Version note: This is version 3 of the alpha doesn't contain the compass plate that is visible in the photo. I added a wedge gap for flexibility. I found the fit didn't have enough tension so I lowered the tolerance to .025mm. If you still find it to loose, you can adjust the wedge or simply add a thin piece of painters tape on the cylinder, I find painters tape has just the right amount of friction.
General Note: I suggest you align with an actual scope first and replace with the phoneholder. Then write down your compass and clinometer readings for future sessions. Remember to make sure you are level.
Hope you find this useful.
The modular design failed my first test, still working on it.