1 / 4
New End for Ettore Rea-c-h Squeegee and Paint Extension Pole
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
New thread and / or taper for pole. Also included make your own hole versions
- Ocena
- 5 / 5
- Polubienia
- 8
- Pobrania
- 100
- Wydruki
- 1
- Wyświetlenia
- 421
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (8)Wydruki i komentarze (Wydruki: 1) (Komentarze: 2)Remiksy (0)Kolekcje (14)Powiązane
I had the Ettore Extension pole with the threads broken off the end of the taper… so I made a new one.
I cut the original off by slicing the plastic on two sides and pushing it off. I probably did not need to do that as there was no effective glue holding it. You could see some glue residue.
The new one is a snug fit so I tapped it on with a rubber mallet. We will see how it does.
There are several option to choose from:
- Same Same replacement
- A thread only option for people that don't use the taper (in 24mm and 34mm length thread)
- All of the above with NO hole in the bottom so you can add your own for a different ole
- The taper/thread version with a pole thread socket on the bottom… in case you need the taper.
- A set of threads to cut socket into something
I have only printed it in PETG, no supports required when printed upright.