Center Guide (Zentrierhilfe)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Center Guide to help you mark the center of wooden (or other) rods and also usable as gauge
- Ocena
- 5 / 5
- Polubienia
- 21
- Pobrania
- 133
- Wydruki
- 1
- Wyświetlenia
- 350
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Features
This center guide has a few features built in:
- It helps you precisely mark the center of the face of rods
- Can be used to mark 90° or 45° angles on your workpiece
- Can be used as gauge to mark lines parallel to the edge of your workpiece (additional adhesive measuring tape necessary)
To mark the center of rods, you need to put in the rod flush and draw two times a line. The center is where the two lines cross.
The corner of the guide features a hole for avoiding collisions with sharp workpiece corners, when marking a 45° angle from the corner of your workpiece.
The extending leg is 14 mm wide, so that you can glue on an adhesive measure tape (usually 13 mm wide), if you want to use it for marking parallel lines to the edge of your workpiece.
You can find the Onshape model here:
https://cad.onshape.com/documents/b6bd878f553d1eeb4d368b40/w/ab34c397190a3cee1d7bb9ad/e/151853f44ff2a779d15aaaf4?renderMode=0&uiState=66cb5a353e8e314da9d8cf21
Attributions
I have created the model myself from scratch, but got some inspiration from the following works: