Support Bracket for IKEA TROFAST
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Stop bins from falling out of your IKEA TROFAST storage unit.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 23
- Wydruki
- 0
- Wyświetlenia
- 441
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution
If your bins are falling out of your IKEA TROFAST storage unit, these support brackets will help. The bins fit into slots cut into the unit, but if you load the bins up with anything heavy they tend to fall out. These supports add just a few extra millimetres of support on either side and that seems to be enough to correct the problem.
Shown are a picture of the slots before and after installation of the supports. I put two brackets in each slot: one near the front and one near the middle.
There is also a picture of the screws I used to install the brackets (I drilled first). The screws can be up to 5/8" in length. Screw head diameter can be up to 6.5mm (the brackets have countersunk holes so that the screw heads do not stick out).
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
No
Supports:
No
0.15mm
Infill:
15%
Notes:
I printed these without a brim on the MK3S and, despite the small footprint, they did not come away from the print bed.
Category: Organization