HTC Vive DAS BMR Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adapted BillyAlt's design from the Vive Pro head strap to work with the Deluxe Audio Strap (DAS).
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 29
- Wydruki
- 0
- Wyświetlenia
- 317
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Virtual Reality
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is relatively nondestructive and you can revert the mod if needed.
A 0.2mm layer height should work fine.
The mount can be used for the left and right sides of the DAS, you will need to take apart the hinge mechanism of the original headphones to extract the threaded metal peg that goes into the DAS for each side. To do so there is a metal “c” clip that holds in each hinge that you will need to pop off. A pair of tweezers worked for me.
Wiring is simple connect each speaker to your choice of either a 2.5mm or 3.5mm audio jack. I recommend not to use thin headphone enamel wire, the resistance may be a little too high. I noticed a slight reduction in volume on the right speaker with the longer run of wire.
To drive the speakers I used a Qudelix 5k over USB and the 2.5mm balanced output. The built in EQ is great for tuning in the drivers. I found some EQ settings from sctanf's github page that worked great. (v5.5 sounded the best)